I am posting this in Marketplace, because I can't find suitable section for jobs.
Three (3) jobs recently opened up at my company, Epson Canada. And, they are asking help from employees in search for candidates.
> 1. Machine Learning Research Scientist (Robotics Control) for EDGE
This is R&D robotic 2nd floor. The focus is more on algorithm, but Linux is part of discussion during lunch.
> 2. Firmware/Embedded Developer for RTSC
> 3. Software Technical Support Representative for RTSC
These two are in my group 1st floor, and definitely Linux related.
If you're interested or know of someone who is interested, then let me know and I can send you more "official" details. Eventually, you'll be applying directly.
--William
This is as good a spot as many. We don't get that many posts for jobs but perhaps I should create one for the future.
Btw, great to see you again, William! Welcome back!
Quote from: William on April 28, 2019, 12:00:34 AM
I am posting this in Marketplace, because I can't find suitable section for jobs.
Three (3) jobs recently opened up at my company, Epson Canada. And, they are asking help from employees in search for candidates.
> 1. Machine Learning Research Scientist (Robotics Control) for EDGE
This is R&D robotic 2nd floor. The focus is more on algorithm, but Linux is part of discussion during lunch.
> 2. Firmware/Embedded Developer for RTSC
> 3. Software Technical Support Representative for RTSC
These two are in my group 1st floor, and definitely Linux related.
If you're interested or know of someone who is interested, then let me know and I can send you more "official" details. Eventually, you'll be applying directly.
--William
The job posts are finally public. Go to
epson.ca > Careers (at the bottom) > Search on "Markham" location
Or,
https://jobs.epson.com/job/Markham-C20018-SOFTWARE-TECHNICAL-SUPPORT-SPECIALIST-ON/557380000/
https://jobs.epson.com/job/Markham-C20007-SOFTWARE-DEVELOPER-II-ON/557379700/
https://jobs.epson.com/job/Markham-C20036-RESEARCHER-ON/549369600/
--William
Thanks for posting William! Good to see you on the Forums.
Bill